Panki
BOFH
- Messages
- 13,104
Hey guys,
Im making a project for school, for physic. Its about Ultrasonic measurements.
It's based on the Arduino Micro Controller.
(Mine is a bit smaller)
I got a US sensor pack for 1 euro. My goal is to programm the Arduino that it:
Sends an impulse (40kHz), and gets it back. Then i can make it visible on the oscilloscope. It works like this:
Transmitter| ---> --> -> |Receiver
It would be perfect if it would show the distance on a display, but thats very hard
Do you have any ideas how i can make it better?
Regards, Panki
PS: I'll post more soon!
Im making a project for school, for physic. Its about Ultrasonic measurements.
It's based on the Arduino Micro Controller.
(Mine is a bit smaller)
I got a US sensor pack for 1 euro. My goal is to programm the Arduino that it:
Sends an impulse (40kHz), and gets it back. Then i can make it visible on the oscilloscope. It works like this:
Transmitter| ---> --> -> |Receiver
It would be perfect if it would show the distance on a display, but thats very hard
Do you have any ideas how i can make it better?
Regards, Panki
PS: I'll post more soon!
